1 Post - Page: 1

Welding up Holes

Welding up Holes
After searching the internet I came across a neat little trick that
works really well. I place a peice of copper behind the hole I am
filling in with my M.I.G, so that when im welding the copper helps to
stop the thin steel from blowing out. The steel will not stick to the
copper so when I am done the weld is already flat on the face that the
copper was held against.


I got two of these from the bargin bin at bunnings for $5. I think
they were ment to be replacment parts for a hammer with copper ends.
1967 Datsun B10 2 Door.
1 Post - Page: 1