Hey guys,
 
I stumbled across these while looking for a set of seats similar to my mates Lotus 7. They look awesome, probably not the most comfortable, but they are identical to the ones he's got. Not too badly priced in my opinon either.
 
http://www.autosports.com.au/index.php/our-brands/manufacturer/view/35
 
I like these ones personally

The last set of SAAS seats I had were god aweful and very heavy. These dont have much of a back, so I can sit them backwards a heap further (Good for me as I'm 6" tall).

And they are skinny as f***!! Even if I used my Datto as a daily, the longest trip is only 15min from one side of town to the other, so its not too bad. Plus the Mrs can using a sewing machine, so she can put some "Material" and padding on the arse for me!

A good thing to remember when bolting in aftermarket seats is the issue of the transverse box channel that the front seats mount to. I put some Cobra Classics in mine and ran into all sorts of problems...the stock seats are offset from thier mounts quite a bit so bolting in seats directly above the mounts will result in the steering wheel not being centered and the edge right up against the b-pillars/ door at the side...but if you try to shift them over to compensate, you hit the box channel where it runs up over the trans. tunnel.
(I think it was Beetwenty that had a 1k where the previous owner had actually chopped the channel to fit seats in?!!!! one hard corner in that thing and it couldve folded in half!)
After a LOT of faffing i managed to center it using spacers both below and above the offset rails I made...sits a lkittle high, but as they are brand new seats, im hoping the padding will sink a bit over time
I guess the Cobras are a bit wider than some of these seats too around the base, so yeh skinnier the better without cuting off too many major ateries