I am asking if some one could post a picture of there front balance with good and fender off. Mine is rusted so bad that bit is non existing 

This area is quite easy mainly flat panels hope my paint modded pics help.
The first one doesnt need the curve in the inside corner as its just to make sure the bonnet closes
but will be better with a pic, Ill try and get one for you  but follow the halve cm lip on the engine
bay parallel side and then continue the lip for about 3 cm as it runs parallel to the guard channel.
So just after is turns you need 3cm of lip metal to guide water away from firewall.
 
The second one is much easier just needs one curved section other mainly flat panels and all
is covered by the guard anyway so weld it all up, blast it, underoate it, stoneguard and tar it up.